The club has an excellent facility for both land and water based aircraft (i.e. floatplanes, seaplanes, etc.). The two fightlines: Flying Field and Waterfront (Dock) are far enough apart that both can operate independently.
- All flyers must join Model Aeronautics Association of Canada (MAAC) and be a member of the club and MAAC in good standing. Please be prepared to show your current annual card if requested. Visiting flyers must be accompanied by a club member, unless alternate arrangements have been made.
- New pilots must be trained following the club’s Wings Program. Pilots new to the club or returning to the hobby may be required to submit to a review by a club instructor prior to flying on their own. Any questions can be answered by a club instructor or executive member.
- Flying hours are 9:00am until dusk 7 days per week. Quiet electrics can fly at any time.
- Mufflers are mandatory on all internal combustion engines – with proper expansion chamber / baffles etc. (cannot be flow through designs).
- In the event you lose your aircraft in the Solar Panel field DO NOT RETRIEVE IT! Contact Craig or Nico. We will make the appropriate arrangements to recover your airplane.
- Please keep your dog properly leashed and controlled. Bring your pooper scooper. You cannot fly and have control of an animal at the same time.
- Last person leaving the flying site at any time of day must close and lock the gates.
- M.A.A.C. Safety Code and Safety Guidelines for Field Operation apply. Copies are available from the club executive or on the MAAC website then click on Advisory Group – Safety.
- Use of the frequency control board is mandatory for all radios on frequencies other than 2.4 GHz.
- The flight line and area of operation are clearly defined.
- The Pit area is for pilots, assistants, and escorted guests only. Please ensure your guests / children act appropriately.
- Large aircraft (with engine size 30cc and up) MUST NOT be started on the assembly benches. Please use the provided starting gates at each end of the pits or suitable hold downs when starting large aircraft.
- Maximum of 4 aircraft in the air at one time, not including any floatplanes or small electrics. Common sense should dictate the number of aircraft in the air at any time.
- Absolutely NO flying behind the pits or over the field behind the club’s property.
- Please fly from the designated pilot stations, behind the safety fence.
- No flying while field maintenance is in progress.
- Vehicles must be parked in the designated area north of the garage after unloading. (Except when float flying).
- A tag must be fixed to the frequency board indicating that the dock area is in use for flight operations. A separate area on the frequency board is provided for this purpose. Members planning to operate from the dock area should prepare a tag or similar to affix to the frequency board before using the dock area.
- The frequency to be used must be indicated. It is highly recommended that operations from the dock area be restricted to 2.4 GHZ radios.
- Flight operations should not interfere directly with normal operations at the land strip.
- Exercise extreme caution when crossing the flight line on the way to the dock area.
- Close gate to deck area when leaving to keep geese off of the deck.
- Water is shallow at dock, NO DIVING ALLOWED.
- The “buddy” system applies at the dock – don’t fly alone.
- It is recommended that an additional person to act as a “spotter” to ensure float operations do not encroach on land operations.
- Parking should be at a safe location.
Model Identification Cards
Cards are now formatted to letter sized paper with ten cards per sheet. Download PDF document
Member ID card example
To comply with MAAC Procedure MPPD 10 – Owner Contact Info (as posted on MAAC website) all models must be identified as follows:
- Member’s MAAC number (required)
- MAAC website address: www.maac.ca (required)
- MAAC office phone number (855-359-6222) or members home/cell phone number (required)
- Members name (optional)
- After printing, add the appropriate information, sign the back, and place in each of your models.